EL3 for Switch Pro controller] - 4x replacement analog joystick work with Nintendo Switch Pro and some PS3 controllers The thumbstick module was made by ALPS This RKJXV stick controller series comes with 10KO trimmer potentiometers compatibility] - This version of analog stick comes in dark gray bottom plate with two plastic sticks inserting in the PcB It locks in 3 directions when not sit in controller cover The trim pot resistors can be in green or black It is widely used in Switch Pro controller Some reported it is also used in 8Bitdo SNES controllers Additional Resistor] - complicated moving mechanism and daily wear and tear finally caused drifting Even new sensors cannot be 100% balanced calibrating in controller settings might not work We packed 10x correction resistors to solve the potential problem in hardware level Solder one or two paralleled tiny resistors onto the potentiometer at the opposite direction against drifting It will help correct 3 to 5 degrees drifting When to replace] - The analog joystick needs to be replaced when your controller has the problem of drifting, creeping, stuttering, a blind spot, a dead spot, a dead zone, no reaction when clicking, or it wouldnt center after years of wear and tear The OEM genuine repair parts ensure accuracy and prolong lifespan Reminder of Operation] - With as many as 14 prongs, de-soldering and soldering the whole module takes serious skills Professional repair with a heat gun is suggested You can simply replace the side potentiometer sensor alone to solve most of the joystick problems
View full description
Item# : A114561545
Model # :
