WoodBudget Cable Railing System
WoodBudget System replaces the composite turnbuckle with two simple Left and Right lag screws—MUZATA CK17. It is a clean-looking, sturdy and economical solution for horizontal,angled and vertical cable railing systems.
The system includes:
Cable railing kit -lag screw (CK17)
Level protector sleeve(CR13)
Angle protector sleeve(CR68)
Wire rope (WR01 )
Hydraulic crimper and cable cutter (CK12)
Drill guide (CT09)
We can help you with these for free
Design a custom cable railing project
Recommend products
Offer a complete material list
Estimate the budguet
Help you to buy everything in 5 minutes
After-sales service
Check image-6 to reach us
Cost-effective
We replace the complex turnbuckle with two simple lag screws, which not only simplifies the system but also cuts down the budget.
Clean Look
A great choice for minimalist style. The system looks just like a few neat lines without other view-blocking fittings. They are made of quality stainless steel.
Easy to install
They are beginner-friendly cable railing kits. Just screw the lag screws into wood posts. A custom wrench is attached to speed up the installation.
FAQ
The recommended post spacing between two posts is 3ft-4ft.
The recommended post spacing is 3†according to the 4†sphere test.
The maximum tensioning distance of CK17 is 15 feet. We suggest terminating the cable at each corner.
If you are using the wood posts with sleeves, please use the invisible cable railing kit Muzata CB24 instead.
Notes: Above are some code compliance required in most states. Please consult your local office for building codes to avoid situations that some states
might have special rules of their own, so please choose carefully to comply with them.
Wire Rope WR01 Lag Screw
View full description
Item# : SPM9272592029
Model # : iSH09-M580676mn