Ingersoll Rand  20 Gallon Air Compressor, Vertical Tank, 2 HP

very quite, i use it to run 1/2 drive impact wrench and blow out the fins on the radiator on my buck loader and air tires. works well at this.

This compressor is definitely a step up from any store brand. 100% duty cycle and a cfm rating that will handle most homeowner or shade tree mechanic tools. Much quieter than the cheap direct drive compressors. With a couple inexpensive mods its even quieter. On sale the value can't be beat!

I had to return two of these because of quality problems. One had a defective motor that had to be constantly reset and the other had a regulator air leak out of the box. Sears was nice enough to take back both units and refund my purchase.

bought this compressor to go with a plasma cutter, it had minimal set up requrements, it had no leaks after letting it build to max pressure and is still holding max pressure. I will have to put in a seperate breaker and outlet for it to make sure it has the proper voltage and amps to run good, it is very quiet for an air compressor, I reviewed alot of compressors and this one was the best for the price and what i needed it for. I do plan on using it for other jobs such as impact wrenches and other air tools.

Quiet, doesn't leak air, small enough to stick in the corner and keeps up with most projects.

This is a great little compressor fills up quickly and man it is quite. Replace a red oil-less compressor and its like night and day difference my only complaint is the tank is a little small kicks on right away when using most of my tools but it keeps up just fine. Great tool defiantly worth the money

It work well during the first year (light duty) then the electric engine stopped working, the warranty covered the damage but I had to wait for more than six weeks, the repair was made in a workshop of Ingersoll Rand located in Miami, the customer service was lousy but finally delivered, a week after the clock air pressure controller is broken, so what else can I say?

I needed a larger compressor for a plasma cutter. I had 6 gallon Chinese special that was noisy, leaked and generally sucked. This IR compressor is a dream. After adding the oil and checking it out, I plugged it in to standard 110 outlet and it filled to just under 150 PSI in a few minutes. After a couple hours of use in the garage and several speedy recharges (motor is rated for 100% duty cycle), I left it for a week. A week later it had not lost a single pound of pressure. High quality tools are a joy to work with and the sub $500 price on this unit is a steal.