Craftsman Pro 15 amp Miter Saw. September 08, 2011

I took it out of the box with very little assembly and put up 420' of privacy fence. It cut through 4X4, 2X4, and the fence boards like butter. By far hands down best Miter saw I have owned and the price was even better.

Decent Compound Miter Saw especially if you get it on sale. May 19, 2011

Decent power for making cuts. Easy to adjust. Clamp works great.

Not as much adjustments as other saws. You can not adjust the bevel at the 45 deg like other saws. You have to loosen all the screws on both side of fence since it's a single fence. Even then there is not much you can adjust it.

Should have a way of mounting the table extention from the side and not only from underneath. If you have the saw mounted on a board and you leave the table extention on it's hard to store since it stick out too far. Otherwise you always have to unmount it from your board in order to put on or take off the extention.

Laser is only useful inside. Outside, you can't even see it if the sun is out.

One major problem was the throat plate. When you set the bevel at 45 deg., the saw blade would hit the throat plate. Had to spend and hour filing down the opening to enlarge it so the blade would not hit the plate.

Great Saw September 19, 2010

I've had this saw over four years now and am just finishing a large landscape structure.  This is my fourth major project with it including a couple of crown molding jobs, a kitchen re-model and now this landscape job.  These are all diy jobs.  This saw just gets it done.  I have a good stand that is an earlier version of the Craftsman 22338 stand that makes life easy. 

This saw has been reliable and cuts almost anything accurately.  It is easy to set up your cuts and I love its versatility.  It can kick a little but once you know the saw it's not an issue and the laser is of questionable value as it shows to the left of the actual cut, but is nice for seeing your angles on for example this landscape job where they are simple angles but accuracy is needed so you don't have to cut twice.  Those 4X4X8's aren't light. 

I am using the original blade and it is just about shot but isn't critical for this job and heck I've gotten four or so years out of it.  I might recommend getting another blade for crown molding jobs, but it did fine when new on the two jobs I did. 

This is a tough saw at the diy level.  It's gotten some good reviews over the years comparing with 400 to 500 dollar DeWalt's and Bosch's.  Mine came square out of the box.  I've only had to adjust it once and check it before every job and it was easy to adjust. 

If you need a dual bevel (crown moulding) and a 12 inch cut (greatly increases versatility) that is very helpful on this landscape job, this one is a good choice.  You can find it occasionally down around 290 bucks on sale and I got mine at 269.  At those kinds of prices you can't go wrong. 

The craftsman miter saw was easy to assemble and easy to use. June 16, 2010

The craftsman professional 15 amp compound miter saw works like a charm.  It is easy to use. I am pleased with the way it cuts.  The laser trac is not necessary but its there if you need it.  The price is reasonable and it is even better when you can get it free when you use your Sears credit card rewards points.