Question

Cannot get door control/remote to open door-1/2 hp garage door opener. Green learn light flashing

when trying to clear codes or sync remote

Answers

4 answers

  1. Thank you for your question. The light flashing most likely means the control has detected a fault. The light should blink out the code, then pause and repeat. Check if the light is flashing a particular number of times. If you can reply with a model number I can give you more specific information.

    1. In response to SHC-FredM

      The light blinks 5 times.
      Model 139.53970SRT

      Thanks

    2. In response to SHC-FredM

      Blinking 5 times indicates a RPM sensor failure. The first thing to try with this error is to unplug the opener for a minute then plug it back in to see if it will reset. You can try to disconnect the door and then see if the motor will run. If the motor will run then the sensor likely needs to be replaced. If the motor does not run then the motor or logic board may be the problem. With the door released see it it will raise and lower manualy.

  2. Hi Doesntwork,

    Welcome to the MySears Community!

    I would be happy to escalate this issue to our Sears Electronic Experts to help with troubleshooting. Do you by chance know the make and model number to this unit? This information maybe helpful to our Experts in helping to provide detailed information.

    Thank you!

See More