Product Introduction
The upgraded version of TB6600 is a driver suitable for 57/42 type two-phase hybrid stepping motor with phase current below 4.0A.
Set 7 kinds of subdivisions (1/2A/2B/4/8/16/32) through 6-bit DIP switch
And 8 gear output current (0.5A/1.0A/1.5A/2.0A/2.5A/2.8A/3.0A/3.5A)
Widely used in various small and medium-sized automation equipment and hardware,
Such as: engraving machine, marking machine, cutting machine, laser phototypesetting, plotter, CNC machine tool, crystal grinding machine, automatic assembly equipment, etc.
The best application object is 57 stepper motors and 42 stepper motors with a torque of 1.8N.m and below.
Product features：
DC 9-42V power supply, 12-30V power supply is the best
The control signal input voltage is 3.3-24V universal (no string resistance required)
Subdivision accuracy 1-32 subdivision optional
Output peak current 4.0A
H-bridge bipolar constant current drive
Input signal high-speed optocoupler isolation
Built-in temperature protection and overcurrent protection
Automatic half flow to reduce heat generation
Motor noise optimization function
Small size, save space
This number of subdivisions is selected and set by the dial switch on the drive board. T
He user can set according to the data of the subdivision selection table on the drive box(preferably set when the power is off)
Step angle is calculated by the following method: step angle=motor inherent step angle/number of subdivisions.
For example: A stepping motor with an inherent step angle ofd. 8"under 4 subdivisions has a step angle of 1.8/4=0.45
DIP switch on drive board 1, 2, and 3 on the drive board correspond to S1, S2, and S3 respectively
The EN terminal can be left unconnected. When EN is valid, the motor rotor is in a free state (off-line state).
At this time, you can manually rotate the motor shaft to make adjustments that suit you.
After the manual adjustment is completed, set EN to an invalid state to continue automatic control.
View full description
Item# : SPM9268506229
Model # : iSH09-M636209mn
