REMOVING THE FLOORING SHOE
1. Disconnect the tool from the air supply.
2. Remove fasteners from the tool. Failure to do so will cause the fasteners to eject from the front of the tool.
3. Lift up the D-shaped pin to an upper location(Fig.1).
4. Pull down the quick release lever to release the flooring nose cover(Fig.2→Fig.3→Fig.4).
5. Pull open the D-shaped pin with force, and take it off the pin slot, and then remove the flooring nose cover(Fig.5→Fig.6→Fig.7).
6. Push the quick release lever back to the nose cover, and it becomes a regular 18 gauge nailer/stapler 2 in 1 tool, make sure the no mar tip is mounted.
INSTRUCTION OF FLOORING SHOE ADJUSTMENT
1. Take off the no mar tip(this is only for finish and trim works), no need to use the no mar tip for flooring installation.
2. Adjust the thumb wheel to the deepest depth location(Fig.9).
3. Loosen these shoe adjusting knobs to release the movable shoe and flooring contact piece in a flexible position.
4. Place the contact piece on top of hardwood flooring , and push the nailer towards the hardwood flooring(Fig.10).
5. Place the nose tip flush with the tongue corner of hardwood flooring. Once you are sure the contact piece is flush with the hardwood, and shoe is flush with the subfloor, fasten the adjusting knobs(Fig. 11).
6. Pull the trigger, the staple shoots through the tongue corner.
View full description
Item# : SPM9133767123
Model # : HFS509040SP