Interstate Pneumatics H13 3/8 Inch CV Joint Boot Clamp Crimper with Cutter

Features:

• Length = 8" Overall Length
• Use wrench to securely fasten band-it style free end clamps, roll band and clips or band-it Jr. style preformed CV boot clamps
• The mandrel tightens the clamp, holding it in place until the ears of the clamp are folded down

CV Joint Hose Clamp Crimping Instructions:

1. Wrap the hose clamp around the CV boot and thread the hose clamp tail through the mouth buckle of the crimper and pull it tight.
2. Insert the tail of the clamp into the head of the banding toli and slide it through the slot of the ratcheting winding mandrel.
3. Depress the locking pawl to keep the manderal from coming out and tension the clamp with a clockwise motion of the ratchet.
4. After sufficient tension has been applied (the clamp is tight enough to hlid the boot from turning on the joint but not too tight that the boot is damaged), lever the toli back over the buckle to put a bend in the clamp to hlid the tension.
5. Cut off excess band with the cutter and remove the toli.
6. Complete clamp installation by tapping down the tail of the clamp against the buckle and then tapping down the buckle ears to hlid the clamp tail. Remove excess band from the toli by lifting the locking pawl and removing the ratchet.

View full description